1. Purpose
Bends a running horizontal pipe straight up at 90 degrees at the picked point. Use it when a horizontal run meets a riser, or must turn up into ceiling-hung equipment.
2. Quick video (≤ 2 minutes)
[Video in production — follow the steps below for now.]
3. Steps
- Open a view where the run is clearly visible — 3D or a section works best. [image 01: the horizontal run before the riser]
- Click Up90 in the VP_MEP tab, Draw 3D panel.
- Pick one point right on the pipe body. [image 02: the picked point on the pipe]
- The tool draws a vertical leg 300mm long by default, elbow included. Press Esc to cancel. [image 03: the finished vertical leg]
4. Real-world example
A DN40 horizontal supply run reaches the shaft base and must turn up to the floor above. Click Up90, pick a point close to the shaft — the vertical leg is done, and the riser continues from the new elbow with no manual work-plane switching.
5. Common errors
| Symptom | Fix |
|---|---|
| "Selected element is pinned." | The pipe is pinned — unpin it, then rerun |
| Clicking draws nothing | You missed the pipe — pick a point exactly on the pipe body |
| Elbow faces the wrong way | The pick was too close to the old pipe end — pick mid-run instead, then rerun |
6. See also
- Draw elbow down 90° — the mirror downward bend.
- Draw elbow up 45° — turn diagonally when a square bend is too sharp.